Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna):

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER (for Coupe)





(a) Install the tire pressure warning receiver with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
(b) Connect the connector.
2. INSTALL TIRE PRESSURE WARNING RECEIVER (for Convertible)





(a) Install the tire pressure warning receiver with the nut.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(b) Connect the connector.
3. INSTALL UPPER QUARTER TRIM PANEL LH (for Coupe)





(a) Install the upper quarter trim panel LH.
4. INSTALL UPPER QUARTER TRIM PANEL LH (for Convertible)
5. INSTALL NO. 1 CUP HOLDER (for Convertible)
6. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (for Coupe)
7. INSTALL CENTER PILLAR GARNISH LH (for Coupe)
8. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (for Coupe)
9. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (for Coupe)
10. INSTALL REAR SEATBACK ASSEMBLY (for Coupe)
11. INSTALL REAR SEATBACK ASSEMBLY (for Convertible)

HINT: Refer to the procedures up to "INSTALL REAR SEATBACK ASSEMBLY" (Installation).

12. INSTALL REAR SEAT CUSHION ASSEMBLY (for Coupe) (Installation)

13. INSTALL FRONT DOOR SCUFF PLATE LH (for Coupe)
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
(a) When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).
15. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: (Test Mode Procedure).