Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR:

INSTALLATION

1. INSTALL REAR AIRBAG SENSOR LH
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

(c) Install the rear airbag sensor LH with the 2 bolts.
Torque: 17.5 Nm (178 kgf-cm, 13 ft-lbf)

NOTICE:
- If the rear airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the rear airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Connect the connector to the rear airbag sensor LH.
(e) Check that there is no looseness in the installation parts of the rear airbag sensor LH.
2. INSTALL REAR SEATBACK ASSEMBLY LH

HINT: (Installation) coupe, (Installation) convertible

3. CONNECT BATTERY NEGATIVE TERMINAL

NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.





4. INSPECT SRS WARNING LIGHT

HINT: (Problem Symptoms Table)