Installation

SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION ECU:

INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

(c) Install the occupant classification ECU.
(d) Connect the connectors to the occupant classification ECU.

NOTICE:
- If the occupant classification ECU has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

2. INSTALL FRONT RH SEAT ASSEMBLY

HINT: (Removal) power seat, (Removal) manual seat.

3. CONNECT BATTERY NEGATIVE TERMINAL

NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.





4. OCCUPANT CLASSIFICATION ECU INITIALIZATION

HINT: (Programming and Relearning)

5. INSPECT SRS WARNING LIGHT

HINT: (Problem Symptoms Table)