Installation

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY (for Convertible):

INSTALLATION

1. INSTALL CRS ANCHOR BRACKET





(a) Install the bracket with the 2 nuts.
Torque: 18.1 Nm (185 kgf-cm, 13 ft-lbf)
2. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH

NOTE: Do not disassemble the retractor.





(a) Check the degree of tilt when the belt begins to lock the ELR.
(1) When the inclination of the retractor is 15°or less, check that the belt can be pulled from the retractor. When the inclination of the inclination of the retractor is over 45°check that the belt locks.
If operation is not as specified, replace the belt assembly.





(b) Install the outer belt with the 3 bolts, as shown in the illustration.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTE: Do not allow the anchor part of the rear belt and the protruding parts of the rear seat adjuster to overlap.

(c) Check the ELR lock.

NOTE: The check should be performed with the outer belt assembly installed.

(1) With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the belt assembly.
(d) Check fastening function of the child restraint system.

NOTE: The check should be performed with the outer belt assembly installed.

(1) When the belt is pulled out fully, the belt should automatically try to retract.
(2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again.
If operation is not as specified, replace the belt assembly.