Side Airbag Sensor

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR:

ON-VEHICLE INSPECTION

Be sure to perform the initialization of the occupant classification ECU if any of the following conditions occur. If the initialization is not performed, the SRS may not operate properly.

- The occupant classification ECU is replaced.
- Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
- The passenger seat is removed from the vehicle.
- Both the SRS warning light and passenger airbag ON/OFF indicator light ("OFF") come on.
- The vehicle is brought to the workshop for repair due to an accident or collision.

1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (DTC Check / Clear).
2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)
(a) Perform a diagnostic system check (DTC Check / Clear).
(b) When the door of the vehicle or its periphery is damaged, check if there is any damage to the side airbag sensor assembly. If there are any defects as mentioned below, replace the side airbag sensor assembly with a new one:

- Cracks, dents or chips in the case.
- Cracks or other damage to the connector.
- Peeling off of the label or damage to the serial number.

3. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
(a) Replace the side airbag sensor assembly (Removal).