Removal

BRAKE CONTROL: SKID CONTROL SENSOR:

REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. SEPARATE SKID CONTROL SENSOR WIRE





(a) Disconnect the connector from the skid control sensor.
3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH

HINT: (Disassembly)

4. REMOVE REAR DISC





(a) Put matchmarks on the rear disc and the axle hub.





(b) Release the parking brake, and remove the rear disc.

HINT: If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.

5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH





(a) Remove the 4 bolts and rear axle hub & bearing assembly.
6. REMOVE SKID CONTROL SENSOR
(a) Mount the rear axle hub in a soft jaw vise.

NOTE: Replace the axle hub & bearing assembly if it is dropped or receives a strong shock.

(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments (09521-00010) from SST.
SST: 09520-00031





(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST: 09520-00031
09520-00040
SST: 09950-00020
SST: 09521-00020

- If damage is inflicted to the sensor rotor, replace the axle hub assembly.
- Do not scratch the contact surface of axle hub and speed sensor.