Reassembly

3MZ-FE STARTING: STARTER:

REASSEMBLY

1. INSTALL PLANETARY GEAR





(a) Apply grease to the planetary gears and pin parts of the planetary shaft.
(b) Install the 3 planetary gears.
2. INSTALL STARTER ARMATURE ASSEMBLY





(a) Apply grease to the plate washer and the armature shaft.
(b) Install the starter armature to the starter commutator end frame.
(c) Using snap ring pliers, install the plate washer and a new snap ring.





(d) Using a vernier caliper, measure length of the snap ring.
Maximum length:
5.0 mm (0.197 in.)
If the length is greater than the maximum, replace it with a new snap ring.
3. INSTALL STARTER COMMUTATOR END FRAME COVER





(a) Install the end frame cover to the commutator end frame.
4. INSTALL STARTER ARMATURE PLATE





(a) Insert the armature plate to the starter field frame.
(b) Align the keyway of the starter plate with the key inside the starter field frame, and install the starter plate.
5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY





(a) Align the rubber of the end frame with the cutout of the field frame.
(b) Install the end frame to the field frame.
6. INSTALL STARTER FIELD FRAME ASSEMBLY





(a) Align the protrusion of the starter field frame with the cutout of the starter drive housing.





(b) Install the field frame with the 2 through bolts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
7. INSTALL MAGNETIC SWITCH ASSEMBLY





(a) Apply grease to the plunger and the hook.
(b) Hang the plunger hook of the magnetic switch to the drive lever.
(c) Install the plunger and return spring.





(d) Install the magnetic switch with 2 screws.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)





(e) Connect the lead wire to the magnetic switch with the nut.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)