Installation

SUSPENSION: FRONT LOWER BALL JOINT:

INSTALLATION

1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
(a) Install the lower ball joint assembly front LH to the steering knuckle with the castle nut.
Torque: 123 Nm (1,250 kgf-cm, 91 ft-lbf)

NOTE: Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

(b) Install a new cotter pin to the steering knuckle.

NOTE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

2. INSTALL FRONT AXLE ASSEMBLY LH (Installation)

3. INSTALL FRONT SUSPENSION NO.1 LOWER ARM SUB-ASSEMBLY (Installation)

4. INSTALL TIE ROD ASSEMBLY LH (Installation)

5. INSTALL FRONT DISC
6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH (Installation)

7. INSTALL SPEED SENSOR FRONT LH (Installation)

8. INSTALL FRONT AXLE SHAFT LH NUT (Installation)

9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

11. CHECK ABS SPEED SENSOR SIGNAL (w/ VSC)

HINT: (Test Mode Procedure)

12. CHECK ABS SPEED SENSOR SIGNAL (W/O VSC)

HINT: (Test Mode Procedure)