Installation

SUSPENSION: REAR NO. 2 LOWER SUSPENSION ARM:

INSTALLATION

1. INSTALL NO.2 REAR SUSPENSION ARM ASSEMBLY LH
(a) Install the rear suspension arm No.2 (inner side) with the bolt and temporarily tighten the bolt.









(1) Ensure that the paint mark faces the rear side of the vehicle.





(b) Set the rear suspension arm in the position shown in the illustration, and fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74 ft-lbf)
2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY (Installation)

3. TEMPORARILY TIGHTEN NO.1 REAR SUSPENSION ARM ASSEMBLY LH (Installation)

4. TEMPORARILY TIGHTEN NO.1 REAR SUSPENSION ARM ASSEMBLY RH

HINT: Temporarily tighten the RH side using the same procedure as for the LH side.

5. TEMPORARILY TIGHTEN NO.2 REAR SUSPENSION ARM ASSEMBLY LH (Installation)

6. TEMPORARILY TIGHTEN NO.2 REAR SUSPENSION ARM ASSEMBLY RH

HINT: Temporarily tighten the RH side using the same procedure as for the LH side.

7. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY
8. STABILIZE SUSPENSION (Installation)

9. FULLY TIGHTEN NO.1 REAR SUSPENSION ARM ASSEMBLY LH (Installation)

10. FULLY TIGHTEN NO.1 REAR SUSPENSION ARM ASSEMBLY RH

HINT: Fully tighten the RH side using the same procedure as for the LH side.

11. FULLY TIGHTEN NO.2 REAR SUSPENSION ARM ASSEMBLY LH (Installation)

12. FULLY TIGHTEN NO.2 REAR SUSPENSION ARM ASSEMBLY RH

HINT: Fully tighten the RH side using the same procedure as for the LH side.

13. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (Installation)

14. INSTALL STABILIZER BAR REAR (Installation)

15. INSTALL CENTER EXHAUST PIPE ASSEMBLY
(a) 2AZ-FE engine: (Installation)

(b) 3MZ-FE engine: (Installation)

16. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
17. INSPECT REAR WHEEL ALIGNMENT

HINT: (Service and Repair)