Installation

AXLE: REAR AXLE CARRIER:

INSTALLATION

1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY LH





(a) Install the rear axle carrier sub-assembly with the 2 bolts and 2 nuts to the shock absorber.
Torque: 180 Nm (1836 kgf-cm, 133 ft-lbf)
2. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH





(a) Temporarily tighten the rear suspension arm assembly No.1 LH with the bolt and nut.

HINT: Insert the bolt from the rear side of the vehicle and temporarily tighten the bolt.

3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH





(a) Temporarily tighten the rear suspension arm assembly No.2 LH with the bolt and nut.

HINT: Insert the bolt from the rear side of the vehicle and temporarily tighten the bolt.

4. TEMPORARILY TIGHTEN STRUT ROD ASSEMBLY REAR
(a) Temporarily tighten the strut rod assembly rear with the bolt and nut.

HINT: Insert the bolt from the inside of the vehicle and temporarily tighten the bolt.

5. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH





(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft-lbf)
6. INSPECT BEARING BACKLASH
7. INSPECT AXLE HUB DEVIATION
8. CONNECT SKID CONTROL SENSOR
(a) Connect the connector.

NOTE: Do not twist the sensor wire when connecting it.

9. INSTALL REAR DISC
10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH





(a) Install the rear disc brake caliper with the 2 bolts.
Torque: 62 Nm (630 kgf-cm, 46 ft-lbf)





(b) Install the bolt with flexible hose to the shock absorber.
Torque: 19 Nm (192 kgf-cm, 14 ft-lbf)
11. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
12. INSTALL STABILIZE SUSPENSION
13. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH
14. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH
15. FULLY TIGHTEN STRUT ROD ASSEMBLY REAR
16. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
17. CHECK ABS SPEED SENSOR SIGNAL
(a) with VSC: (Test Mode Procedure)

(b) without VSC: (Test Mode Procedure)