Reassembly

U151E AUTOMATIC TRANSAXLE: OIL PUMP:

REASSEMBLY

1. INSTALL FRONT OIL PUMP OIL SEAL





(a) Using SST and a hammer, install a new oil seal to the oil pump body.
SST: 09350-32014
09351-32140

HINT: The seal end should be flat with the outer edge of the oil pump.

(b) Coat the lip of the oil seal with MP grease.
2. INSTALL FRONT OIL PUMP BODY O-RING





(a) Coat the new O-ring with ATF, install it to the oil pump body.

NOTE: Assemble the O-ring carefully not to have a twist and a pinching. Moreover, apply enough ATF to the O-ring prior to assembling.

3. INSTALL FRONT OIL PUMP DRIVEN GEAR





(a) Coat the front oil pump driven gear with ATF, install it to the oil pump body with the marked side up.
4. INSTALL FRONT OIL PUMP DRIVE GEAR





(a) Coat the front oil pump drive gear with ATF, install it to the oil pump body with the marked side up.
5. INSTALL STATOR SHAFT ASSEMBLY





(a) Set the stator shaft aligned with each bolt hole.
(b) Using a "TORX" socket (T30), install the 11 bolts.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
6. INSTALL CLUTCH DRUM OIL SEAL RING





(a) Coat the 2 new clutch drum oil seal rings with ATF.
(b) Install the 2 new clutch drum oil seal rings.

NOTE: Do not expand the ring ends excessively.