Installation

U151E AUTOMATIC TRANSAXLE: TRANSMISSION WIRE:

INSTALLATION

1. INSTALL TRANSMISSION WIRE





(a) Coat an O-ring of the transmission wire connector with ATF.
(b) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
2. CONNECT TRANSMISSION WIRE





(a) Coat an O-ring of the ATF temperature sensor with ATF.
(b) Install the ATF temperature sensor with the lock plate and bolt.
Torque: 6.6 Nm (67 kgf-cm, 58 in-lbf)
(c) Connect the 7 shift solenoid valve connectors.
3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY





(a) Install the 2 magnets in the oil pan.
(b) Apply seal packing or equivalent to the 18 bolts.
Seal packing:
Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent





(c) Using a new gasket, install the oil pan with the 18 bolts to the transaxle case.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)

NOTE: Apply seal packing to the bolts and tighten them within 10 minutes of application.

4. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:
ATF type T-IV
Capacity:
3.5 liters (3.7 US qts, 3.1 lmp. qts)
5. INSPECT AUTOMATIC TRANSAXLE FLUID
HINT: (Procedures).

6. INSTALL ENGINE UNDER COVER LH
7. RESET MEMORY
HINT: (Programming and Relearning).