Installation

WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS (for Convertible):

COMPONENTS





INSTALLATION

1. INSTALL QUARTER WINDOW REGULATOR MOTOR





(a) Apply MP grease to the sliding and rotating areas of the quarter window regulator and motor.





(b) With the holding tool installed, match the holding tool with the motor housing.
(c) Push down on the wire guide and drum, insert the drum into the motor housing.

NOTE: If you cannot insert the drum into the motor, slowly slide the bracket for installing the glass, and insert the drum while aligning the drive shaft of the motor with the drum.





(d) Install the cover with the 2 screws.
2. INSTALL QUARTER WINDOW REGULATOR SUB-ASSEMBLY LH





(a) Apply MP grease to the sliding and rotating parts of the quarter window regulator.

NOTE: Do not apply grease to the spring of the quarter window regulator.





(b) Install the quarter window regulator with the 6 nuts.
Nut A - Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
Nut B - Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
Nut C - Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
3. INSTALL QUARTER WINDOW ASSEMBLY LH





(a) Insert the quarter window glass into the door and put it on the quarter window regulator.
(b) Connect the connector.
(c) Move the quarter window regulator until the bolts appear in the service hole.





(d) Install the quarter window glass with the 3 nuts.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
4. INSTALL QUARTER SERVICE HOLE COVER LH





(a) Apply butyl tape to the quarter panel.
(b) Install the quarter service hole cover.

HINT:
- There should be no wrinkles or folds after attaching the quarter service hole cover.
- Check if the quarter service hole cover is securely attached.