Removal

WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS (for Convertible):

COMPONENTS






REMOVAL

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Standard Bolt - How To Determine Bolt Strength).

1. REMOVE REAR SEAT HEADREST ASSEMBLY
2. REMOVE REAR SEAT CUSHION ASSEMBLY (Removal)

3. REMOVE REAR SEATBACK ASSEMBLY (Removal)

4. REMOVE QUARTER TRIM PANEL LOWER LH

HINT: (Removal)

(a) Remove the rear seat outer belt LH.
(b) Remove the front door scuff plate LH.
(c) Remove the cup holder hole cover.
(d) Remove the cup holder No. 2.
(e) Remove the quarter trim panel upper LH.
(f) Remove the quarter trim panel lower LH.
5. REMOVE QUARTER TRIM PAD
6. REMOVE SPEAKER BRACKET REAR
(a) Remove the 3 bolts and speaker bracket rear with rear speaker.
7. REMOVE CUP HOLDER BRACKET NO.2
(a) Remove the 2 bolts and cup holder bracket.
8. REMOVE QUARTER PANEL EXTENSION REINFORCEMENT LH
(a) Remove the 3 bolts and reinforcement.
9. REMOVE QUARTER WINDOW GLASS RETAINER SUB-ASSEMBLY REAR LH
(a) Remove the 3 bolts and glass retainer.
10. REMOVE QUARTER BELT MOULDING LH
11. REMOVE CENTER PILLAR UPPER END WEATHERSTRIP LH





(a) Remove the 4 clips and center pillar upper end weatherstrip.
12. REMOVE QUARTER SERVICE HOLE COVER LH





(a) Remove the quarter service hole cover.

NOTE: Remove the remaining tape on the door side.

13. REMOVE QUARTER WINDOW ASSEMBLY LH





(a) Move the quarter window glass until the 3 nuts appear in the service holes.





(b) Remove the 3 nuts.

NOTE: Be careful when removing the nuts as the quarter window glass may fall and become damaged.





(c) Move the quarter window regulator down enough so that the quarter window glass can be removed.

HINT: Hold onto the quarter window glass to prevent it from falling.

(d) Remove the quarter window glass.

NOTE: Be careful not to damage the quarter window glass.

14. REMOVE QUARTER WINDOW REGULATOR SUB-ASSEMBLY LH





(a) Disconnect the connector.
(b) Remove the 6 nuts and quarter window regulator.

NOTE: Be careful when removing the nuts as the quarter window regulator may fall and become damaged.

HINT: Remove the quarter window regulator through the service hole.

15. REMOVE QUARTER WINDOW REGULATOR MOTOR





(a) Remove the 2 screws and cover.





(b) Using needle nose pliers, remove the drum and wire guide from the motor.

NOTE: Do not use a screwdriver to remove them. Using a screwdriver may damage the regulator wire.