Timing Component Alignment Marks: Locations

NOTE: For information relating to the complete Timing Chain service procedures, please refer to Timing Chain; Service and Repair. Service and Repair


INSTALL CHAIN SUB-ASSEMBLY





(a) Make sure that all the timing marks are in the positions (TDC) shown in the illustration.
HINT: The positions of the timing marks may differ from the predetermined positions due to the force of the valve spring.





(b) Set the timing mark of the crankshaft in a position between 40 and 140°ATDC as illustrated.






(c) Set the camshaft timing gear and the camshaft timing sprocket in the positions ( 20°ATDC) shown in the illustration.
(d) Set the crankshaft in the position ( 20°ATDC) shown in the illustration.






(e) Install chain vibration damper No. 1 with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)






(f) Align the timing marks of the camshaft with the mark plates of the timing chain and install the timing chain.
HINT: Align the timing marks with the mark plates while turning the hexagonal service portion of the camshaft using a wrench.