Installation

1NZ-FE COOLING: WATER PUMP:

INSTALLATION





1. INSTALL WATER PUMP ASSEMBLY
(a) Install the water pump assembly through a new gasket with the 3 bolts and 2 nuts.
Torque: 11 Nm (112 kgf-cm, 8.1 ft-lbf)
2. INSTALL WATER PUMP PULLEY
(a) Provisionally install the water pump pulley with the 3 bolts.






(b) Using SST, hold the water pump pulley.
SST: 09960-10010
09962-01000
09963-00700
(c) Tighten the 3 bolts to the specified torque.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH (for Hatchback) Installation

4. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH (for Sedan) Installation

5. INSTALL GENERATOR ASSEMBLY

6. INSTALL FAN AND GENERATOR V BELT Installation

7. ADJUST FAN AND GENERATOR V BELT Installation

8. INSPECT FAN AND GENERATOR V BELT Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
10. ADD ENGINE COOLANT Service and Repair

11. CHECK FOR ENGINE COOLANT LEAKAGE Testing and Inspection

12. INSTALL ENGINE UNDER COVER RH