Removal

1NZ-FE FUEL: FUEL SENDER GAUGE ASSEMBLY (for Hatchback):

REMOVAL
NOTE: Always use "Torx" socket wrench E10 when removing the rear seat.

1. REMOVE REAR SEAT CUSHION COVER PAD (for Hold Down Seat Type) Removal

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type) Removal

3. REMOVE DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type) Removal

4. REMOVE DECK FLOOR BOX (for 60/40 Split Seat Type) Removal

5. REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) Removal

6. REMOVE NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) Removal

7. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type) Removal

8. REMOVE REAR FLOOR SERVICE HOLE COVER Removal

9. DISCHARGE FUEL SYSTEM PRESSURE Removal

10. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY Removal

12. DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY Removal

13. REMOVE FUEL PUMP GAUGE RETAINER Removal

14. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY Removal

15. REMOVE FUEL SENDER GAUGE ASSEMBLY





(a) Disconnect the fuel sender gauge connector.






(b) Unlock the fuel sender gauge, and slide and remove it.