Removal

BRAKE CONTROL: SKID CONTROL SENSOR:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR WHEEL
3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY Removal

4. DISCONNECT SKID CONTROL SENSOR WIRE Removal

5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY Removal







6. REMOVE SKID CONTROL SENSOR
(a) Install the 4 hub nuts and the 4 hub bolts onto the rear axle hub, and then fix the rear axle hub in a vice between aluminum plates.
NOTE: If the skid control sensor is dropped or heavily damaged, replace the rear axle hub and bearing.

(b) Using a 3 mm pin punch and hammer, remove the 2 pins from SST (09520-00031) and remove the attachment (09521-00010).
(c) Using SST and the 2 bolts (90101-12007), remove the skid control sensor from the rear axle hub.
SST: 09520-00031
09520-00040
SST: 09521-00020
SST: 09950-00020
NOTICE:
- Pull the skid control sensor off straight, being careful not to make contact with the skid control sensor rotor.
- If the skid control sensor rotor is damaged or deformed, replace the rear axle hub and bearing.
- Do not damage the skid control sensor or rear axle hub contact surfaces.
- Keep the sensor rotor free of foreign matter.