Installation

2GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

INSTALLATION

1. INSTALL V-RIBBED BELT





(a) Install the V-ribbed belt.
(b) Using SST, turn the belt tensioner counterclockwise and remove the bi-hexagon wrench.
SST: 09961-00950





(c) If it is difficult to install the V-ribbed belt, perform the following procedure.
(1) Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.
(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulleys.

NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.

2. INSTALL V-BANK COVER SUB-ASSEMBLY
3. INSTALL FRONT FENDER APRON SEAL RH
4. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)