Installation

2GR-FE EMISSION CONTROL: CANISTER: INSTALLATION

INSTALLATION

1. INSTALL CHARCOAL CANISTER ASSEMBLY
(a) Install the 2 bolts, clip and charcoal canister.
Torque: 36 Nm (367 kgf-cm, 27 ft-lbf)
(b) Connect the purge line hose to the charcoal canister.
(c) Connect the wire harness clamp.
(d) Connect the vapor pressure sensor connector.
(e) Connect the charcoal canister filter sub-assembly to the charcoal canister.
(f) Connect the fuel tank vent hose to the charcoal canister.
2. INSTALL FUEL TANK ASSEMBLY Installation
3. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3 Installation
4. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.2 Installation
5. INSTALL EXHAUST PIPE ASSEMBLY CENTER
6. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY
7. ADD FUEL
8. CONNECT BATTERY NEGATIVE TERMINAL
9. CHECK FOR FUEL LEAKS
10. CHECK FOR EXHAUST GAS LEAKS
11. INSTALL REAR FLOOR SERVICE HOLE COVER
12. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
13. PERFORM SYSTEM INITIALIZE
Some systems need initialization when disconnecting the battery terminal.