Installation

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR





(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(b) Connect the 2 knock control sensor connectors.
2. INSTALL INTAKE MANIFOLD
3. INSTALL INTAKE AIR SURGE TANK
4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. ADD ENGINE COOLANT Service and Repair
7. INSPECT FOR COOLANT LEAK Service and Repair
8. INSPECT FOR FUEL LEAK Testing and Inspection
9. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
10. INSTALL COWL TOP PANEL OUTER Installation
11. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY Installation
12. CHECK FUNCTION OF THROTTLE BODY On-Vehicle Inspection