Installation
AXLE: REAR AXLE CARRIER: INSTALLATION
INSTALLATION
1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY LH
(a) Install the rear axle carrier sub-assembly LH with the 2 bolts and 2 nuts to the shock absorber.
Torque: 180 Nm (1835 kgf-cm, 132 ft-lbf)
2. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH
(a) Temporarily tighten the rear suspension arm assembly No.1 LH with the bolt and nut.
HINT: Insert the bolt from the rear side of the vehicle and temporarily tighten the bolt.
3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH
(a) Temporarily tighten the rear suspension arm assembly No.2 LH with the bolt and nut.
HINT: Insert the bolt from the rear side of the vehicle and temporarily tighten the bolt.
4. TEMPORARILY TIGHTEN STRUT ROD ASSEMBLY REAR
(a) Temporarily tighten the strut assembly rear with the bolt and nut.
HINT: Insert the bolt from the inside of the vehicle and temporarily tighten the bolt.
5. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft-lbf)
6. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing
7. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub and Bearing
8. CONNECT SKID CONTROL SENSOR
(a) Connect the skid control sensor connector.
NOTE: Do not twist the sensor wire when connecting it.
9. INSTALL REAR DISC
10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Install the rear disc brake caliper with the 2 bolts.
Torque: 62 Nm (632 kgf-cm, 46 ft-lbf)
NOTE: Do not twist the brake hose when installing the rear disc brake caliper assembly LH.
(b) Install the rear flexible hose with the bolt.
Torque: 19 Nm (192 kgf-cm, 14 ft-lbf)
11. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
12. STABILIZE SUSPENSION Installation
13. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH Installation
14. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH Installation
15. FULLY TIGHTEN STRUT ROD ASSEMBLY REAR Installation
16. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust rear wheel alignment Service and Repair.
17. CHECK FOR SPEED SENSOR SIGNAL
(a) Check for the speed sensor signal Test Mode Procedure.