Removal

EXTERIOR: FRONT BUMPER: REMOVAL

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)





(a) Remove the 7 clips and cool air intake duct seal.
2. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)





(a) Put protective tape around the front bumper assembly.





(b) Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
HINT: Use the same procedures for the RH side and LH side.





(c) Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.





(d) Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
HINT: Use the same procedures for the RH side and LH side.

(e) Remove the front bumper assembly.
3. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)





(a) Put protective tape around the front bumper assembly.





(b) Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
HINT: Use the same procedures for the RH side and LH side.





(c) Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.





(d) Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
HINT: Use the same procedures for the RH side and LH side.

(e) Disconnect each connector, and then remove the front bumper assembly.