Installation

2AZ-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

INSTALLATION

1. INSTALL V-RIBBED BELT





(a) Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the V-ribbed belt.
SST: 09216-42010
NOTICE:
- Be sure to align SST and the wrench parallel during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply force any more than necessary.

(b) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Check to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.
2. INSTALL FRONT FENDER APRON SEAL RH
3. INSTALL ENGINE UNDER COVER RH
4. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1050 kgf-cm, 76ft-lbf)