Installation

f


U250E AUTOMATIC TRANSAXLE: SHIFT LEVER: INSTALLATION

INSTALLATION

1. INSTALL SHIFT LOCK CONTROL UNIT





(a) Connect the shift lock ECU connector and transmission control switch wire connector.
(b) Install the 4 bolts and shift lock control unit.
Torque: 12 Nm (122 kgf-cm, 9ft-lbf)
2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Install the transmission control cable assembly as shown in the illustration.
HINT:
- Install the floor shift cable with the uneven surface facing up.
- Securely engage the claws of the floor shift cable.

3. INSTALL FLOOR CARPET BRACKET LH
4. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made) Installation
5. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made) Installation
6. INSTALL CONSOLE BOX ASSEMBLY (for TMC Made) Installation
7. INSTALL CONSOLE BOX ASSEMBLY (for TMMK Made) Installation
8. INSTALL CONSOLE BOX CARPET Installation
9. INSTALL CONSOLE BOX POCKET Installation
10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made) Installation
11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made) Installation
12. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Installation
13. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation
14. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
15. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY





(a) Install the shift lever knob sub-assembly.
17. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation
18. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) Installation
19. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) Installation
20. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
21. INSTALL FRONT DOOR SCUFF PLATE LH Installation
22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 6.9 Nm (70 kgf-cm, 61in-lbf)
23. INSPECT SHIFT LEVER POSITION Adjustments
24. ADJUST SHIFT LEVER POSITION Adjustments