Installation

U250E AUTOMATIC TRANSAXLE: TRANSMISSION WIRE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION WIRE





(a) Coat a new O-ring of the transmission wire connector with ATF WS and install it to the transmission wire.





(b) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
(c) Connect the transmission wire connector.
2. CONNECT TRANSMISSION WIRE





(a) Coat the O-ring of the ATF WS temperature sensor with ATF.
(b) Install the ATF temperature sensor with the lock plate and bolt.
Torque: 6.6 Nm (67 kgf-cm, 58in-lbf)
(c) Connect the 7 shift solenoid valve connectors.
3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY





(a) Install the 2 magnets in the oil pan.
(b) Apply adhesive or equivalent to new 18 bolts.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent





(c) Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69in-lbf)
NOTICE: Since the bolts should be seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.

4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
HINT: Installation.