Reassembly

SLIDING ROOF: SLIDING ROOF HOUSING: REASSEMBLY

REASSEMBLY

1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY
(a) Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.




NOTICE: Make sure that the spring indicated by the arrow in the illustration is securely installed.
HINT: Hold the window deflector down, as shown in the illustration, until the sliding roof drive cable sub-assembly runs on the window deflector.





(b) Engage the 2 claws and install the sliding roof drip channel.





(c) Install the 2 sliding roof side stoppers with the 2 screws.
Torque: 2.0 Nm (20 kgf-cm, 18in-lbf)
2. ADJUST FULLY CLOSED POSITION





(a) Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.
HINT: Tape the screwdriver tip before use.

3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY





(a) Insert the sunshade trim into the sliding roof housing sub-assembly.





(b) Install the sliding roof piece sub-assemblies LH and RH with the 2 screws.
Torque: 2.0 Nm (20 kgf-cm, 18in-lbf)
4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY





(a) Install the sliding roof drive gear sub-assembly with the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)





(b) Engage the claw and install the sliding roof room light bracket.