Reassembly

SEAT: FRONT SEAT ASSEMBLY (for Power Seat): REASSEMBLY

REASSEMBLY
CAUTION: Wear protective gloves. Sharp areas on the seat adjuster may injure your hands.

1. INSTALL FRONT SEAT WIRE
2. INSTALL SEAT POSITION SENSOR (for Driver Side) Installation
3. INSTALL FRONT LOWER SEAT CUSHION SHIELD
4. INSTALL FRONT LOWER SEAT CUSHION SHIELD LH
5. INSTALL SEAT RECLINING ADJUSTER INSIDE COVER LH
6. INSTALL SEAT RECLINING ADJUSTER INSIDE COVER RH
7. INSTALL RECLINING ADJUSTER INSIDE COVER LH
8. INSTALL RECLINING ADJUSTER INSIDE COVER RH
9. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY
10. INSTALL FRONT SEPARATE TYPE SEATBACK COVER





(a) Using hog ring pliers, install the front separate type seatback cover to the front seatback pad with 16 new hog rings.
NOTICE :
- Be careful not to damage the cover.
- When installing the hog rings, take care to minimize wrinkles as much as possible.

11. INSTALL FRONT SEPARATE TYPE SEATBACK ASSEMBLY





(a) Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.
Torque: 5.5 Nm (56 kgf-cm, 49in-lbf)
NOTICE :
- For vehicles with side airbags, the seatback cover must be securely installed. Otherwise, the side airbags may not deploy properly.
- Make sure that the strap is not twisted after installing the bracket.
- Install the bracket securely.





(b) Engage the 3 hooks.
(c) Using hog ring pliers, install 2 new hog rings.
NOTICE:
- Be careful not to damage the cover.
- When installing the hog rings, take care to minimize wrinkles as much as possible.

12. INSTALL FRONT SEAT HEADREST SUPPORT
13. INSTALL FRONT SEAT HEADREST SUPPORT
14. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY
15. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER





(a) Using hog ring pliers, install the front separate type seat cushion cover to the front separate type seat pad with 16 new hog rings.
NOTICE :
- Be careful not to damage the cover.
- When installing the hog rings, take care to minimize wrinkles as much as possible.

16. INSTALL FRONT SEPARATE TYPE SEAT CUSHION ASSEMBLY
17. INSTALL FRONT POWER SEAT SWITCH
18. INSTALL LOWER SEAT TRACK SPACER
19. INSTALL FRONT INNER SEAT CUSHION SHIELD
20. INSTALL FRONT LUMBAR POWER SEAT SWITCH
21. INSTALL FRONT SEAT INNER BELT ASSEMBLY Installation
22. INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD
23. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
24. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
25. INSTALL RECLINING POWER SEAT SWITCH KNOB
26. INSTALL OCCUPANT DETECTION ECU Installation