Installation

BRAKE CONTROL: BRAKE CONTROL POWER SUPPLY: INSTALLATION

INSTALLATION

1. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY





(a) Install the No. 2 brake control power supply bracket with the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
(b) Install the No. 2 brake control power supply bracket with the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
2. INSTALL BRAKE CONTROL POWER SUPPLY WITH BRACKET





(a) Install the brake control power supply with bracket with the 3 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
(b) Connect the brake control power supply connector and install the clamp.
3. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH Installation
4. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation
5. INSTALL LUGGAGE COMPARTMENT REAR TRIM COVER Installation
6. INSTALL REAR FLOOR FINISH PLATE Installation
7. INSTALL LUGGAGE COMPARTMENT TRIM HOOK NO.1 Installation
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. CLEAR DTC FOR BRAKE CONTROL SYSTEM
HINT: Refer the procedures up to "ELECTRONICALLY CONTROLLED BRAKE SYSTEM". Reading and Clearing Diagnostic Trouble Codes

10. PERFORM INITIALIZATION
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal. Repair Instruction - Initialization