Removal

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR (for TMMK Made): REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal
4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal
5. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Removal
6. REMOVE FRONT DOOR SCUFF PLATE LH Removal
7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal
8. REMOVE FRONT DOOR SCUFF PLATE RH Removal
9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal
10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH Removal
11. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Removal
12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal
13. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Removal
14. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal
15. REMOVE CONSOLE BOX POCKET Removal
16. REMOVE CONSOLE BOX CARPET Removal
17. REMOVE CONSOLE BOX ASSEMBLY Removal
18. REMOVE NO. 2 CONSOLE BOX INSERT FRONT Removal
19. REMOVE NO. 1 CONSOLE BOX INSERT FRONT Removal
20. REMOVE NO. 1 CONSOLE BOX DUCT Removal
21. REMOVE YAW RATE AND ACCELERATION SENSOR





(a) Disconnect the yaw rate and acceleration sensor connector.
(b) Remove the 2 bolts and yaw rate and acceleration sensor.
NOTICE: Do not remove the yaw rate and acceleration sensor from the bracket.