Installation

BRAKE: REAR BRAKE: INSTALLATION

INSTALLATION
HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below are for the LH side.

1. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY





(a) Install the rear disc brake cylinder assembly with the 2 bolts.
Torque: 27 Nm (275 kgf-cm, 20ft-lbf)
NOTICE: Install the rear disc brake bushing dust boot onto the groove of the rear disc brake cylinder.





(b) Connect the rear brake flexible hose with the union bolt and a new gasket.
Torque: 33 Nm (337 kgf-cm, 24ft-lbf)
2. ADD BRAKE FLUID TO RESERVOIR Service and Repair
3. BLEED REAR BRAKE SYSTEM Service and Repair
4. CLEAR DTC FOR BRAKE CONTROL SYSTEM
HINT: Refer the procedures up to "ELECTRONICALLY CONTROLLED BRAKE SYSTEM". Reading and Clearing Diagnostic Trouble Codes

5. PERFORM ACCUMULATOR PRESSURE ZERO DOWN Service and Repair
6. CHECK BRAKE FLUID LEVEL IN RESERVOIR Service and Repair
7. INSPECT FOR BRAKE FLUID LEAK
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)