Removal

BRAKE CONTROL: SKID CONTROL SENSOR: REMOVAL

REMOVAL

1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE





(a) Disconnect the connector from the skid control sensor.
NOTICE: Be careful not to damage the speed sensor.

3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly
4. REMOVE REAR DISC Disassembly
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR Removal
6. REMOVE SKID CONTROL SENSOR





(a) Mount the rear axle hub in a vise using aluminum plates.
NOTICE: Replace the hub and bearing assembly if it is dropped or receives a strong shock.

(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST: 09520-00031
09521-00010
09520-00040
SST: 09521-00020
(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the hub and bearing assembly.
SST: 09520-00031
09521-00010
09520-00040
SST: 09521-00020
SST: 09950-00020
NOTICE:
- Keep the sensor away from magnets.
- Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
- If the speed sensor rotor is damaged or deformed, replace the hub and bearing assembly.
- Do not scratch the contact surface between the axle hub and the skid control sensor.
- Do not attach foreign matter to the speed sensor rotor and tip.