Installation

METER: COMBINATION METER: INSTALLATION

INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY
(a) Using the tilt and telescopic functions, fully lower and extend the steering wheel.





(b) Connect the 2 connectors as shown in the illustration.
(c) Secure the wire harness to the combination meter assembly.





(d) Install the combination meter assembly as shown in the illustration.





(e) Install the 4 screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL





(a) Engage the 4 claws and the guide.
(b) Install the instrument cluster finish panel with the 2 clips.
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMC Made) Installation
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMMK Made) Installation
5. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) Installation
6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) Installation
7. INSTALL STEERING COLUMN COVER





(a) Engage the claw and install the upper steering column cover.





(b) Engage the 2 claws.
(c) Install the lower steering column cover with the 2 screws.
Torque: 2.0 Nm (20 kgf-cm, 18in-lbf)
8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH
(a) Install the air hose and connect each connector.





(b) Engage the claw and the 9 clips.
(c) Connect the hood lock control cable assembly.
(d) Install the lower instrument panel finish panel LH with the screw and bolt.
9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
10. INSTALL FRONT DOOR SCUFF PLATE LH Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.