Installation

2AZ-FXE ENGINE CONTROL SYSTEM: CAMSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CAMSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring of the sensor.
NOTICE: Make sure that the O-ring is not cracked or jammed when installing it.





(b) Install the camshaft position sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
(c) Connect the camshaft position sensor connector.
2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Removal
4. INSTALL AIR CLEANER INLET ASSEMBLY Installation
5. INSPECT FOR OIL LEAK
6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation