Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY (for TMC Made): INSTALLATION

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the center airbag sensor assembly with the 3 bolts.
Torque: 17.5 Nm (179 kgf-cm, 13ft-lbf)
NOTICE :
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(e) Connect the holder (with connectors).
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

(f) Check that the water-proof sheet is properly set.
2. INSTALL NO. 1 CONSOLE BOX DUCT Installation
3. INSTALL NO. 2 CONSOLE BOX INSERT FRONT Installation
4. INSTALL NO. 1 CONSOLE BOX INSERT FRONT Installation
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
6. INSTALL CONSOLE BOX ASSEMBLY Installation
7. INSTALL CONSOLE BOX CARPET Installation
8. INSTALL CONSOLE BOX POCKET Installation
9. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
10. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Installation
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
12. INSTALL FRONT DOOR SCUFF PLATE RH Installation
13. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Installation
14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
15. INSTALL FRONT DOOR SCUFF PLATE LH Installation
16. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Installation
17. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation
18. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
19. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
20. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
22. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

23. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.