Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL REAR AIRBAG SENSOR
(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the rear airbag sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
NOTICE :
- If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.
(e) Connect the connector.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL REAR SIDE SEATBACK ASSEMBLY Installation
3. INSTALL ROOF SIDE INNER GARNISH Installation
4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
5. INSTALL REAR DOOR SCUFF PLATE Installation
6. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

9. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.