Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SIDE AIRBAG SENSOR
(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the side airbag sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
NOTICE :
- If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the side airbag sensor.
(e) Connect the connector.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER CENTER PILLAR GARNISH Installation
3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP Installation
4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP Installation
5. INSTALL REAR DOOR SCUFF PLATE Installation
6. INSTALL FRONT DOOR SCUFF PLATE Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

9. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.