Removal

2AZ-FXE EMISSION CONTROL: FUEL TANK PRESSURE SENSOR: REMOVAL

REMOVAL

1. REMOVE FUEL TANK CAP ASSEMBLY
HINT: Removal

2. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
3. REMOVE REAR FLOOR SERVICE HOLE COVER Removal
4. REMOVE VAPOR PRESSURE SENSOR ASSEMBLY





(a) Disconnect the connector.





(b) Remove the cover and tube joint clip, and pull out the vapor pressure sensor.
- Before this operation, check that there is no dirt or other foreign objects around the connector. Clean the connector if necessary.
- It is necessary to prevent mud or dirt from entering the connector. If mud or dirt gets in the connector, the O-ring may not seal properly.
- Do not use any tools for this operation.
- If the fuel suction plate and vapor pressure sensor are stuck, carefully try wiggling or pushing and pulling on the vapor pressure sensor to release it. Pull the sensor off the suction plat carefully.