Installation

AXLE: REAR AXLE HUB AND BEARING: INSTALLATION

INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY





(a) Install the hub and bearing assembly with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59ft-lbf)
(b) Connect the skid control sensor connector.
NOTICE: Do not twist the sensor wire when connecting it.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing
3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub and Bearing
4. INSTALL REAR DISC Reassembly
5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
7. CONNECT SKID CONTROL SENSOR CONNECTOR Installation
8. CHECK ABS SPEED SENSOR SIGNAL
HINT: Test Mode Procedure.