Diesel Data: Automotive Repair
Home >> Toyota >> 2009 >> Camry L4-2.4L (2AZ-FXE) Hybrid >> Repair and Diagnosis >> Transmission and Drivetrain >> Continuously Variable Transmission/Transaxle >> Transmission Position Sensor/Switch >> Service and Repair >> Installation

Installation








P311 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SHIFT LEVER POSITION SENSOR
(a) Install the shift lever position sensor to the manual valve shaft.





(b) Temporarily install the 2 bolts.





(c) Install a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61in-lbf)
(d) Temporarily install the control shaft lever.





(e) Turn the lever clockwise until it stops, then turn it counterclockwise 2 notches.
(f) Remove the control shaft lever.





(g) Align the protruding part with the neutral basic line.
NOTICE: There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.





(h) Tighten the 2 bolts in the order shown in the illustration.
Torque: 13 Nm (133 kgf-cm, 10ft-lbf)





(i) Using a screwdriver, secure the nut with the lock plate.





(j) Install the control shaft lever, washer, and nut.
Torque: 13 Nm (133 kgf-cm, 10ft-lbf)
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to the N position.
(b) Install a new clip to the control bracket.





(c) Install the transmission control cable assembly to the control bracket.
NOTICE :
- Make sure that the A claws on the clip are securely fit into the bracket holes.
- Make sure that the cable is securely installed inside the B claws of the clip.





(d) Connect the shift lever position sensor connector.
(e) Move the control shaft lever to the N position.





(f) Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque: 15 Nm (150 kgf-cm, 11ft-lbf)
3. INSPECT SHIFT LEVER POSITION Adjustments
4. ADJUST SHIFT LEVER POSITION Adjustments
5. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY Adjustments
6. INSPECT SHIFT LEVER OPERATION Adjustments
7. INSTALL AIR CLEANER INLET ASSEMBLY Installation
8. INSTALL ENGINE UNDER COVER LH
9. INSTALL ENGINE UNDER COVER RH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
Diesel-Data.com