Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FRONT SPEED SENSOR





(a) Install the front speed sensor with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
NOTICE: Prevent foreign matter from attaching to the sensor tip.





(b) Install the front speed sensor with the 2 bolts and engage the 2 claws.
Bolt A - Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
Bolt B - Torque: 19 Nm (194 kgf-cm, 14ft-lbf)
NOTICE:
- Do not twist the wire harness for the front speed sensor when installing the speed sensor.
- The bolt B tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.
- Install the stopper firmly to the hole in the body.





(c) Connect the front speed sensor connector and clamp.
2. INSTALL FRONT FENDER LINER Installation
3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH Installation
4. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
5. CHECK SPEED SENSOR SIGNAL
HINT:
- for BOSCH without VSC Test Mode Procedure
- for BOSCH with VSC Test Mode Procedure
- for ADVICS Test Mode Procedure