Installation

2GR-FE ENGINE CONTROL SYSTEM: CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE (for Bank 2 Intake Side)

(a) Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve.

(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
NOTICE: Make sure that the O-ring is not cracked or jammed when installing the oil control valve.

(c) Connect the camshaft timing oil control valve connector.
5. INSTALL INTAKE AIR SURGE TANK Installation
6. INSTALL NO. 1 AIR CLEANER INLET Installation
7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
9. INSTALL AIR CLEANER INLET ASSEMBLY Installation
10. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
11. INSTALL COOL AIR INTAKE DUCT SEAL Installation
12. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY

(a) Install the cowl top panel outer sub-assembly with the 4 bolts and 4 nuts.
Bolt - Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
Nut - Torque: 85 Nm (867 kgf-cm, 63ft-lbf)
13. INSTALL WINDSHIELD WIPER MOTOR AND LINK Installation
14. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
15. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
16. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
17. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Installation
18. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Installation
19. ADD ENGINE COOLANT Testing and Inspection
20. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
21. INSTALL ENGINE UNDER COVER RH
22. INSTALL ENGINE UNDER COVER LH