Installation

2GR-FE EXHAUST: EXHAUST PIPE: INSTALLATION

INSTALLATION

1. INSTALL REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET





(a) Install the rear support bracket with the 2 bolts.
Torque: 33 Nm (337 kgf-cm, 24ft-lbf)
NOTICE: Be sure to install the bracket in the correct direction.

2. INSTALL HEATED OXYGEN SENSOR Installation
3. INSTALL EXHAUST FRONT PIPE ASSEMBLY
(a) Install 2 new gaskets to the exhaust front pipe.
(b) Install the exhaust front pipe to the exhaust manifolds with the 4 nuts.





Torque: 62 Nm (632 kgf-cm, 46ft-lbf)
4. INSTALL FRONT EXHAUST PIPE NO. 1 SUPPORT BRACKET





(a) Install the front support brackets with the 2 nuts.
Torque: 33 Nm (337 kgf-cm, 24ft-lbf)
NOTICE: Be sure to install the support brackets in the correct direction.

5. INSTALL EXHAUST CENTER PIPE ASSEMBLY
(a) Install a new gasket to the exhaust center pipe assembly.
(b) Install the exhaust center pipe to the exhaust front pipe with the 2 nuts and 2 bolts.





Torque: 56 Nm (571 kgf-cm, 41ft-lbf)
6. INSTALL EXHAUST TAIL PIPE ASSEMBLY
(a) Install 2 new gaskets to the exhaust tail pipes.
(b) Install the 2 exhaust tail pipes with the 4 nuts.





Torque: 43 Nm (438 kgf-cm, 32ft-lbf)
7. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.