Installation

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR





(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.
Torque: 20 Nm (204 kgf-cm, 15ft-lbf)
(b) Connect the 2 knock control sensor connectors.
2. INSTALL INTAKE MANIFOLD Installation
3. CONNECT FUEL TUBE SUB-ASSEMBLY Installation
4. INSTALL INTAKE AIR SURGE TANK Installation
5. INSTALL NO. 1 AIR CLEANER INLET Installation
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
8. INSTALL AIR CLEANER INLET ASSEMBLY Installation
9. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
10. INSTALL COOL AIR INTAKE DUCT SEAL Installation
11. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY Installation
12. INSTALL WINDSHIELD WIPER MOTOR AND LINK Installation
13. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
14. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
15. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
16. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Installation
17. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Installation
18. ADD ENGINE COOLANT Testing and Inspection
19. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
20. CHECK FOR FUEL LEAKS Testing and Inspection
21. INSTALL ENGINE UNDER COVER RH
22. INSTALL ENGINE UNDER COVER LH