Crankshaft Main Bearing
MAIN BEARING CAPStep 1
Install and uniformly tighten the 16 main bearing cap bolts in the sequence shown in the illustration.
Torque: 61 Nm (622 kgf-cm, 45 ft-lbf)
If any of the main bearing cap bolts does not meet the torque specified, replace it.
Step 2
Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts by 90° in the order above.
Check that the painted marks are now at a 90° angle to the front.
Install 8 new seal washers and uniformly tighten the 8 main bearing cap bolts in several steps and in the sequence shown in the illustration.
Torque 52 Nm (525 kgf-cm, 38 ft-lbf)
Bolt Length
Bolt A 45 mm (1.77 in.)
Except bolt A 30 mm (1.18 in)
Crankshaft bearing cap set bolt diameter
Standard 10.8 to 11.0 mm (0.4252 to 0.4331 in.)
Maximum 10.7 mm (0.4213 in.)
Main journal diameter 60.988 to 61.000 mm (2.4011 to 2.4016 in.)
Main journal taper and out-of-round
Maximum 0.02 mm (0.0008 in.)
Crankshaft oil clearance:
Standard 0.026 to 0.047 mm (0.0010 to 0.0019 in.)
Maximum 0.050 mm (0.0020 in.)