Cylinder Head Assembly
CYLINDER HEAD SUB-ASSEMBLY RHStep 1
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps and in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
Step 2
Mark the cylinder head bolt heads with paint as shown in the illustration.
Tighten the cylinder head bolts another 90°.
Step 3
Tighten the cylinder head bolts by an additional 90°.
Check that the painted marks are now facing rearward.
CYLINDER HEAD SUB-ASSEMBLY LH
Step 1
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
Step 2
Mark the cylinder head bolt heads with paint as shown in the illustration.
Tighten the cylinder head bolts by 90°.
Step 3
Tighten the cylinder head bolts by an additional 90°.
Check that the painted marks are now facing rearward.
Tighten the 2 bolts in the order shown in the illustration.
Torque 30 Nm (306 kgf-cm, 22 ft-lbf)
CYLINDER HEAD SET BOLT
Outside diameter
Standard 10.85 to 11.00 mm (0.4272 to 0.4331 in.)
Minimum 10.70 mm (0.4213 in.)
Cylinder head Warpage
Lower 0.05 mm (0.0020 in.)
Intake 0.08 mm (0.0031 in.)
Exhaust 0.08 mm (0.0031 in.)
Maximum 0.10 mm (0.0039 in.)
INTAKE MANIFOLD
Install and tighten the 6 bolts and 4 nuts uniformly in several steps.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)
CAMSHAFT BEARING CAP (for RH Bank)
Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)
CAMSHAFT BEARING CAP (for LH Bank)
Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)
EXHAUST MANIFOLD SUB-ASSEMBLY LH
Install the exhaust manifold sub-assembly LH with the 6 nuts.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)
EXHAUST MANIFOLD SUB-ASSEMBLY RH
Install the exhaust manifold sub-assembly RH with the 6 nuts.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)
CAMSHAFT TIMING GEAR/SPROCKET
Torque 100 Nm (1020 kgf-cm, 74 ft-lbf)