Installation

SUSPENSION: REAR NO. 2 SUSPENSION ARM: INSTALLATION

INSTALLATION

1. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM





(a) Install the rear No. 2 suspension arm (inner side) with the bolt, and temporarily tighten the bolt.
HINT: Ensure that the paint mark faces to the rear of the vehicle.





(b) Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
NOTICE: When temporarily tightening the bolt, keep the nut from rotating.

2. STABILIZE SUSPENSION Installation
3. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM





(a) Fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74ft-lbf)





(b) Fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74ft-lbf)
4. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT Service and Repair