Installation

U660E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL NO. 2 SHIFT CABLE GROMMET RETAINER
(a) Pass the control cable from the cabin to the engine compartment.





(b) Install the No. 2 shift cable grommet retainer with the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to the N position.





(b) Install the transmission control cable assembly as shown in the illustration.
HINT:
- Install the floor shift cable with the uneven surface facing up.
- Securely engage the claws of the floor shift cable.





(c) Connect the control cable to the bracket with a new clip.





(d) Install the control cable to the control shaft lever with the nut.
Torque: 13 Nm (130 kgf-cm, 9ft-lbf)





(e) Push in the lock piece of the transmission control cable.
NOTICE: Firmly push in the lock piece until the slider lock is engaged.
HINT: After pushing in the lock piece, make sure that the boot is not deformed.

3. INSTALL CENTER AIRBAG SENSOR ASSEMBLY Installation
4. INSTALL AIR CONDITIONING UNIT
HINT: Installation

5. INSTALL NO. 1 AIR CLEANER INLET Installation
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
8. INSTALL AIR CLEANER INLET ASSEMBLY Installation
9. INSTALL COOL AIR INTAKE DUCT SEAL Installation
10. INSPECT SHIFT LEVER POSITION Adjustments
11. ADJUST SHIFT LEVER POSITION Adjustments