Installation

DRIVE SHAFT: FRONT DRIVE SHAFT (for TMMK Made): INSTALLATION

INSTALLATION

1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation
3. INSTALL FRONT AXLE ASSEMBLY Installation
4. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM Installation
5. INSTALL TIE ROD END SUB-ASSEMBLY Installation
6. INSTALL FRONT SPEED SENSOR Installation
7. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation
8. INSTALL FRONT AXLE HUB NUT Installation
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
10. ADD AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle)
(a) for 2GR-FE: Procedures
(b) for 2AZ-FE:
11. ADD MANUAL TRANSAXLE OIL (for Manual Transaxle)
12. INSPECT AUTOMATIC TRANSAXLE FLUID (for 2AZ-FE, Automatic Transaxle)
13. INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle)
14. ADJUST FRONT WHEEL ALIGNMENT
HINT: Service and Repair

15. CHECK ABS SPEED SENSOR SIGNAL
(a) ABS: Test Mode Procedure
(b) VSC (for BOSCH): Test Mode Procedure
(c) VSC (for ADVICS): Test Mode Procedure