Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Using SST, install the center airbag sensor assembly with the 3 bolts.
SST: 09961-01270
without SST - Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
with SST - Torque: 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
- Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
- This torque value is effective when SST is parallel to a torque wrench.
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- When the ignition switch is first turned to ON after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the holder (with connectors).
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(f) Check that the waterproof sheet is properly set.
2. INSTALL CONSOLE BOX ASSEMBLY (for Manual Transaxle) Installation
3. INSTALL CONSOLE BOX ASSEMBLY (for Automatic Transaxle) Installation
4. INSTALL CONSOLE BOX CARPET Installation
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
6. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
7. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
8. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation
9. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Installation
10. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Installation
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation
12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation
13. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Installation
14. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL RH Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.